Conquest 3/8″ x 3′ A307 Coarse Threaded Rod Plain Finish

The Conquest 3/8″ x 3′ A307 Coarse Threaded Rod is built for long-run anchoring, spanning structural supports, and framing configurations that demand uninterrupted length. Manufactured to ASTM A307 Grade A standards, it provides reliable performance for light-duty applications in dry, indoor environments.

When pairing a nut with threaded rod, the material and finish must match. If these do not match, the nut will not fit the threaded rod.

Extended-Length Rod for Long Framing and Anchor Runs

This 3-foot rod is ideal for applications where full-span stability is required without mid-point joins. Fully threaded and ready to cut or couple, it gives installers maximum flexibility for adapting to jobsite conditions and layout demands.

Key Features

• ASTM A307 Grade A: Suitable for indoor light-duty structural and support tasks.
• 3/8″-16 Thread Pitch: Quick engagement and compatibility with standard fasteners.
• 3-Foot Length: Reduces need for splicing or couplers in long framing runs.
• Plain Finish: Economical for clean, dry installation conditions.
• Fully Threaded: Allows hardware placement anywhere along the rod.

Common Applications

• Framing utility racks or service supports
• Suspending conduit, cable trays, or ductwork
• Long-span through-bolt anchoring
• Custom fixture and bracket fabrication
• Non-corrosive facility maintenance projects

Installation Tips

• Use thread-matched hardware and tighten fully for proper load bearing.
• Install in environments where rust protection isnt required.
• Trim to desired length if customization is needed.

California Residents: WARNING

When pairing a nut with threaded rod, the material and finish must match. If these do not match, the nut will not fit the threaded rod.

Conquest A307 Threaded Rod is a dependable fastening solution for light-duty structural and general-purpose projects. Manufactured to ASTM A307 Grade A standards, this threaded rod provides consistent tensile strength and performance in applications where high strength or corrosion resistance isnt required.

The plain steel finish keeps costs down while remaining ideal for indoor environments or temporary installations. Its fully threaded design allows for flexible adjustment, cutting, and joiningperfect for through-bolting, bracing, anchoring, and custom-length fastening tasks.

Contractors, facility managers, and DIYers trust threaded rod as a go-to choice in commercial construction, maintenance work, and shop fabrication.

Key Features:

• ASTM A307 Grade A Standard: Delivers reliable strength for non-critical joints and assemblies.
• Fully Threaded Design: Enables cutting to length, extending, and anchoring flexibility.
• Plain Finish Steel: Ideal for dry indoor use where corrosion resistance isn’t a top concern.
• Universal Compatibility: Works with standard nuts, washers, and coupling nuts.
• Field-Friendly Form: Easily cut or modified on-site to meet project requirements.

Common Uses:

• Hanging electrical or plumbing supports
• Framing bracing and tension tie-downs
• Anchoring machinery and light equipment
• HVAC, conduit, and pipe suspension
• Repair and retrofit work

California Residents: WARNING